This kit is for all you DIY guys and gals that want more from your backfire. Designed to be plug and play aside from mounting your esc.
This kit includes 1 set of direct drives or belts drives in the voltage of your choosing with the matching voltage esc and remote mounted on Double king pin trucks with abec mounts.
Top Speed: 55km/h+ (Depending on your build and Vesc or esc) 45-50km/h for rx1 and 50-55km/h for rx2
Max Power: 4000W
Max Amps: 55A
KV Rating: 72
Max Voltage: 12s
Motor Diameter: 70mm with Sleeve
Both Motor Weight: 6lbs
Motor Phase Wire Connector: Male MR30
- Direct Drive Motors
- Rear Motor Truck 12 Inches
- Front Truck 12 Inches
- (2) Wheel Adapters
- (2) MR30 Connectors
- 97mm Wheels.
The Beserker Remote:
Remote Paring Mode instructions
- Press and hold remote power button for 6 seconds
- press and hold power button on board for 6 seconds
- Unit of measurement system settings - this setting will give you options to select two units of measurements “Km/h - km & Mp/h - Miles”
- Motor style system settings - “Hub & Belt“
- Wheel diameter system settings - wheel options from 80mm to 175mm
- Wheel gear system settings - ratio settings
- Main menu
Remote Power on instructions
- Press and hold power button on remote for 3 seconds power on.
- Press and hold power button on remote for 3 seconds when board is not in motion to power off.
Remote speed mode instructions
- (1) Slow mode up to 25km/h
- (2) Eco mode up to 35km/h reduced initial power for reduced energy consumption.
- (3) turbo mode 45km/h plus (please message us for top speed on a closed circuit track)
Remote reverse instructions
- Bring your board to a complete stop.
- double click the lower big 3 line slashed oval mode selector button located below the power button to change wheel direction to either forward or reverse as indicated by the arrow on the far right section of the lcd on the remote.
- double click again to change wheel direction again.
Remote cruise control instructions
- With your board and remote on and in motion use the thumb dial on the remote to set your desired speed under 32km/h.
- Then click the mode select for button to log your current speed and output.
- Maintain your thumb wheel position for 4 seconds after the initial mode selector button click.
- Enjoy your set cruising speed.
- To exit cruise control move the thumb wheel forward or backwards to increase speed or decrease speed and smoothly exit cruise control.
REMOTE ERROR SCREENS
(if you have any of these issues please contact Eskatet.email@example.com)
- Motor stall motor lcd notification with vibrations
- Overheat notification that persists with non extreme use.
- Motor disconnect notification
- Excessive low signal or remote disconnection notifications.
INCLUDED IN BOX IS
- Remote x 1
- USB C 6cm long charge cable x 1
Assembly Difficulty rating = 2/10
Please email us if you have any questions before buying this product.